Constant SPINEL_PROP_GPIO_STATE 

pub const SPINEL_PROP_GPIO_STATE: _bindgen_ty_24 = 4098;

GPIO State Bitmask ** Format: D

• Type: Read-Write
• Contains a bit field identifying the state of the GPIOs. The length of
• the data associated with these properties depends on the number of
• GPIOs. If you have 10 GPIOs, you’d have two bytes. GPIOs are numbered
• from most significant bit to least significant bit, so 0x80 is GPIO 0,
• 0x40 is GPIO 1, etc.
• For GPIOs configured as inputs:
• • CMD_PROP_VALUE_GET: The value of the associated bit describes the

• logic level read from the pin.

• • CMD_PROP_VALUE_SET: The value of the associated bit is ignored

• for these pins.

• For GPIOs configured as outputs:
• • CMD_PROP_VALUE_GET: The value of the associated bit is

• implementation specific.

• • CMD_PROP_VALUE_SET: The value of the associated bit determines

• the new logic level of the output. If this pin is configured as an

• open-drain, setting the associated bit to 1 will cause the pin to

• enter a Hi-Z state.

• For GPIOs which are not specified in PROP_GPIO_CONFIG:
• • CMD_PROP_VALUE_GET: The value of the associated bit is

• implementation specific.

• • CMD_PROP_VALUE_SET: The value of the associated bit MUST be

• ignored by the NCP.

• When writing, unspecified bits are assumed to be zero. */